What are the advantages of the angular setting machine?
The structural principle of the angle-driven machine is basically the same as that of the cement tile automatic press. The difference is that color steel tile press does not need to consider the deformation and maintenance of products after pressing. Always pay attention to the height of the lubricating oil in the sliding box and both sides of the body. The equipment should be cleaned regularly and kept clean. In the early stages of production of ceramic tile also used this kind of hydraulic press for pressing, but because of this kind of model in billet, demoulding, take tile automation is difficult to adapt to the mud material body, easy to produce deformation, so don't meet the requirements for the ceramic tile industry automation, only can be applied in the half mechanization ceramic tile.
Angular setting machine equipment - a method of adjusting the deflecting of the press plate of the angular setting machine, such as running to the right, padding the left corner (feeding frame), or falling to the right.
2, to cover the first chi forming machine equipment machine before and after the two line from the big four really high amount at the top of the shaft is consistent, then after from row to row, looking for a line straight, check, whether the shaft on a straight line, under the shaft into left and right sides.
Angular setting machine equipment - a method of adjusting the deflecting of the press plate of the angular setting machine, such as running to the right, padding the left corner (feeding frame), or falling to the right.
After 3, cover the chi machine equipment, and a row of looking for a good center, and then tighten lock mother, on both sides in the middle wheel is center of good before and after drawing a straight line, adjust the clearance between the upper and lower axis, can be adjusted along the straight line machine.
Angle of chi machine structure principle compared with ceramic tile automatic pressure tile body, the structure of the cement tile tile press principle is relatively simple, mainly by the hydraulic pump, hydraulic sliding plug, fixed platens, cutting activities, pressure tile mould, etc. In principle, therefore, the requirements are simpler, as long as a certain amount of pressure can be achieved. But compared with the former two presses, its product size is larger. So the machine is a little bit bigger. Its working principle is the current process the raw material into the mold, hydraulic pump driving pressure tile mould automatic press, cement sand under the action of pressure filter to more moisture, and crushed into dense and has a certain strength of the cement tile products.